Sangean DDR-22 Spécifications télécharger pdf (Page 17)

Manual tuning - FM

1. Fully extend the telescopic aerial located on the rear of your radio.

Place the telescopic antenna so a that it is as straight as possible

extending either above or below the radio.

2. Press the On / Standby button to switch on your radio.

3. Press the Mode button to select the FM band.

4. Press the Tuning Up or Down button to tune to a station.

The frequency will change in steps of 50kHz. If the radio is tuned to a

station of sufficient signal strength with RDS information present,

then the display may change to show the station name.

5. When the waveband end is reached the radio will recommence tuning

from the opposite waveband end.

6. Set the Volume to the desired setting.

7. To switch off your radio press the On / Standby button.

Setting FM auto(stereo) / mono

1. If an FM station is received with a weak signal some hiss may

be audible. To reduce the hiss press and release the Select button

so that your radio will switch to mono mode.

2. To return to auto(stereo)mode press and release the Select button

so that your radio will switch to auto(stereo)mode.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 40 41

Pas de commentaire

Sangean DDR-22 Spécifications Page 17