Sangean DDR-31+ Manuel d'utilisateur télécharger pdf (Page 26)

22. Press and release the Select button to confirm the alarm

setup setting. The alarm setup setting is stored in the radio.

23. The display will show “Alarm saved” and will appear alarm symbol

indicating the alarm is set.

24. Pres the Tuning Up or Down buttons to select Off. The display will

show “Alarm saved” but the display will not appear alarm symbol.

Note:

If the above alarm setting procedures are not completed, the display

will show “Alarm Not saved“. You may have to start over above

procedures again.

25. The alarm has now been set and the unit will revert to the

previous display. The alarm symbol indicator (alarm 1 or 2) will

show on the display.

Note:

You can also press and hold down the Alarm button to switch the

“Alarm 1 Setup” or the “Alarm 2 Setup” menu, when your clock radio is

in Standby mode. Then press and release the Select button to enter the

“Alarm 1 Wizard“ or “Alarm 2 Wizard“ menu as above described.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 35 36

Pas de commentaire

Sangean DDR-31+ Manuel d'utilisateur Page 26